| Codec : The Voice Codec. Now is fixed to G.72X. |
| 1 |
Indicates the status of the PIXORD VOS |
| 2. |
Voice Enable : Click to enable transmitting streaming voice
on the PIXORD NC. Be sure to you have installed
the PIXORD VOS correctly before selecting this function.
|
| 3. |
Voice Activity Detection: If you enable this feature, the voice server would send voice data only when voice activity is detected on the voice server. As a result, it provides lowest bandwidth payload and good toll quality for Internet environment. |
| 4. |
GPIN: The GPIN status of the voice server. |
| 5. |
GPOUT: To invoke the voice server relay to on and off. |
| 6. |
Click on Submit to make the changes |
| 7. |
Remote Voice Volume: To adjust the Line In Gain on the voice server. The Line In Gain where equal to (value-2)*2 dB, e.g. Line In Gain db Table.
Value |
Line In dB |
0 |
- 4 dB |
1 |
- 2 dB |
2 |
0 dB |
3 |
2 dB |
… |
… |
20 |
36 dB |
Listen / Close: Click to listen to the remote voice acquired by the voice server or not. |
| 8. |
Local Microphone Volume: To adjust the Line Out Gain on the voice server. The Line Out Gain where equal to value*(-6) dB, e.g. Line Out Gain db Table.
Value |
Line Out dB |
0 |
0 dB |
1 |
- 6 dB |
2 |
- 12 dB |
3 |
- 18 dB |
4 |
- 24 dB |
Talk to remote / Close: Click to talk to remotely monitored areas or not.
Status : The status of the talk to remote action.
| Status |
Description |
| Free |
The talk-connection of the voice server is free for everyone to complete the usufruct. |
| On-line |
You have got the usufruct of the talk-connection and it is ready to talk. |
| Connection Occupied |
The talk-connection is occupied by someone and could not be created. You have to wait for talk-connection released. |
|
