The PIXORD NC is capable of detecting NTSC/PAL automatically,
video signal active/lose, fully automatic (plug &
see) and it doesn't need any user configuration.
Quality Adjustments : To adjust
video contrast, brightness, hue, color saturation,quality,
sharpness, backlight, flickerness and light condition..
Note that the
quality level affects the compression ratio and file
size of the video.
NTSC |
PAL |
Resolution |
File size (kb) |
Max fps |
Resolution |
File size (kb) |
Max fps |
VGA (640 x 480) |
7 ¡V 160 |
3 |
VGA (640 x 480) |
9 ¡V 200 |
3 |
QVGA (320 x 240) |
2 - 50 |
30 |
QVGA (320 x 240) |
2 - 60 |
25 |
(The Maximum performance is given in single user and only one video source in use.)
Frame Delay : To set the delay time between frames. The unit of delay time is 10 microseconds. You can limit the output bandwidth via setting the frame delay to do the flow control of the video stream. When the value is set to 0, it means no limitation on the video stream.
Click ¡§ Save Changes ¡¨ bottom
if needed for existing data changed in PIXORD NC when
power off. |
