1 IP Address : PIXORD NC IP address. 2. HTTP Connection Port : Specify the HTTP web server listen port for the client (browser) connection. The default uses port 80 (HTTP standard port), and the valid range from 0~65535. Consider that ports from 0 to 1024 are well known ports, if you customize the port, make sure you are setting the correct one. 3. Gateway IP Address : PIXORD NC traffics to the Internet should go through a Gateway, if this is not set, the NC can only be accessed through the Intranet (LAN). 4. Subnet Mask : Subnet mask of your LAN. Note that the IP Address above and Gateway IP Address below should be in the same subnet. 5. DNS IP Address : Domain name server information allows PIXORD NC to contact external server with a mnemonic domain name (e.g. ftp.PIXORD.com) instead of numeric IP address (e.g. 168.95.1.1). 6. Click “ Submit ” bottom if needed, then PIXORD NC will automatically store the setting and reboot system (within 5 seconds to complete boot sequence) to take the setting effective.

Note: Before changing the listening port, the user must add a port directive “:” in the browser URL in order to get the correct connection. (i.e. http://<IP>:<Port>, e.g. http://192.168.0.200:8000 to access the PIXORD NC with IP 192.168.0.200 and port with 8000).

These features enable user to use PIXORD NC behind NAT or IP Sharing devices which could access up to 65536 PIXORD NC with one IP Address.

The factory default won't change the IP Address and Port setting. Once forgetting the specified port of your PIXORD NC, you must use ARP & Ping setting to restore the port setting back to 80.