Motion Detection
In order to activate the Motion detection, select Enabled.
Once the motion is detected, the MVS will send a text message
to a listening server.
The listening server has to be set to perform any desired action
when it recieves the text message.
Message - Type the message to be sent to the listening server.
IP Address - Enter the IP address of the listening server.
Port - Enter the port of the IP address from the listening server.
Apply - Saves the changes made
GPIO
Only 1 alarm input and 1 relay output are supported.
Relay Output Status -Displays the current state of the relay.
GPIN 1 - Displays the current state of GPIN 1
Relay Output Setting - Change between On and Off
To change the relay setting first select either on or off, then
click Apply.
