| Hardware |
| System |
CPU: 32-bit RISC Processor |
| ROM: 4M Bytes Flash |
| RAM: 32M Bytes SDRAM |
| Watch Dog: Chip to monitor out tolerance system voltage and abnormal program execution |
| Connectors |
1 BNC/ S-Video input and 1 BNC loop back output |
| 1 channel audio input (Available soon) |
| One RJ-45 connector for Ethernet |
| Two LEDs to indicate network and power/ system status |
| GPIO with fully opto-isolated 1 alarm input and 1 relay output |
Two 9-pin D-SUB connectors:
One RS232 serial port for external console,
One RS-232/485 port for PTZ (pan/tilt/zoom) camera control |
| Network |
| Network Interface |
10/100 Base-T Ethernet |
| 802.11b/g Wireless LAN (Optional) |
| Protocols |
TCP/UDP/IP, ARP, ICMP, HTTP, TFTP, FTP, Telnet, SMTP, DHCP, NTP, DNS, DDNS, RTSP |
| Video |
| Image Compression |
MPEG-4 Simple Profile |
| Video Adjustment |
Brightness, Contrast, Hue , Saturation, Image Quality, Image Size, Bit Rate |
| Performance |
30fps at Full D1 resolution |
| Resolutions |
Full D1 V 720x480 (NTSC) / 720x576 (PAL) VGA V 640x480 QVGA V 320x240 SIF V 352x240 (NTSC) / 352x288 (PAL) QSIF V 176x112 (NTSC) / 176x144 (PAL) Quarter QVGA V 160x112 |
| Video Bit rate |
16K ~ 6M bits/sec (CBR/VBR configurable) |
| Management |
| Event Management |
Trigger:
1. Time
2. Sensor Input
3. Motion Detection
4. CGI trigger.
Actions:
1. Store video (AVI format)
2. FTP video to remote site
3. Email with video attachment
4. Relay output to control external device. |
| Installation |
IPInstaller (Win32 Application) |
| Firmware Upgrade |
Remote upgrade by FTP or HTTP |
| Customized web UI is upgradeable via FTP and Telnet |
| Client PC Requirements |
Microsoft IE5.x or above running on Windows ME/ 2000/ XP |
| Security |
Multi-tiered access control |
| Operating Environment |
| Operating Temperature |
5°~50 ° C (40°~125 ° F) |
| Operating Humidity |
20%~80% RHG |
| Input Voltage |
DC 12V, 1A |
| Power Consumption |
< 8 watts |
| Mechanical Design |
| Dimension |
194(L)*180(W)*43(H) mm |
| Approvals |
CE/ FCC |
